Rubber Mould

Why does the domestic mold industry have been fighting the price war? Mar 15, 2019
Why the domestic mold industry has been playing the price war? At present, there are many china tool manufacturer engaged in mold production at home, but the scale is relatively small, the basic model is small workshop, most is cheap mould, and the content of science and technology is very low. Small mold enterprises produce products are basically imitation, resulting in more and...
- China tool manufacturer
- cheap mould
- mold production
The Standardization Degree And Application Level Of Mould Equipment Are Important Signs To Measure The Level Of Mould Industry. Mar 29, 2019
The standardization degree and application level of mould equipment are important signs to measure the level of mould industry. The standardization degree and application level of mould equipment are important signs to measure the level of mould industry. Mold equipment is a special tool for forming tools, although it is highly personalized, but also an industrial product. Therefore, the standardi...
The Precision Of The Mold Will Be Higher And Higher Apr 04, 2019
With the continuous development of the economy, people's living standards are increasing, and the demand for spiritual and material culture is becoming higher and higher. This demand has also led to the continuous development and innovation of the home industry. The industry has a growing demand for home hardware, and the household hardware industry has shown a different change. The mold industry ...
What is Ejector Marks? Apr 12, 2019
Ejector mark is the phenomenon of stress whitening and stress elevation where appears on the opposite side of the nozzle facing the product, or where the ejector rod is located on the ejecting side of the tool. Why will it cause the ejector marks? The physical reason is when the demoulding force is too high or the surface of the ejector rod is relatively small, the surface pressure will be very hi...
- ejector marks
- tool
- demoulding
Injection Mold Cooling Water Leakage Failure and Troubleshooting Apr 22, 2019
Injection mold cooling water leakage is a frequent occurrence, for many reasons, mainly in the following aspects: 1. The most occurs at the joint of the mold cooling water pipe. If water leakage is found, the sealing tape should be wound around the thread of the pipe joint and then tightened. 2. Due to long-term molding conditions, the waterproof ring inside the mold will be damaged, and the O-sha...
Cooling System in Injection Molding (1) Apr 26, 2019
The design of cooling system is very important in injection moulding. This is because only when the plastic parts are cooled and solidified to a certain hardness, can the plastic parts be avoided from deformation due to external force after demoulding. Because the cooling time accounts for about 70% - 80% of the whole cycling time in moulding, a well-designed cooling system can greatly short...
- cooling system
- injection moulding
- moulding time
The program control of injection speed Apr 26, 2019
The program control of the injection speed is to divide the injection stroke of the screw into 3 to 4 stages, and each of the stages uses an appropriate injection speed. For example, when the molten plastic just starts to pass through the gate, the injection speed is slowed down, and during the filling process, high-speed injection is used, and the speed is slowed down at the end of filling. With ...
The main factors affecting mold life May 20, 2019
The main factors affecting mold life. 1. The structure of the mold -effective mold structure helps to improve the load carrying capacity of the mold and reduce the mechanical load on the mold; 2. The material of the mold - should be selected according to the size of the production batch of the product parts; The hardened mold will bring more shots and meet the high require for the mold treat...
- Hardened Mold
- Mold Designing and Machining
- Plastic Components Moulding

1 2 3 4 5 ... 12

A total of 12 pages

Categories

Blog

New Blog

Tags

Search